Oct
20

modify vise settings in TopSolid’Cam

This video will show you how to modify the settings of a vice in TopSolid’Cam (v6).

Oct
20

How to use TopSolid’Cam’s machine simulation

This video will show you how to use TopSolid’Cam’s chronogram to simulate syncronized machining on a mill/turn machine.

Jul
05

TopSolid makes programming WFL machines look easy!

I know it has been a while since my last post.  What can I say…I’m sorry? It won’t happen again? Well, I am sorry.  And I will try not to let it happen again! Anyway, todays post is short, simple and to the point. If you are a mill/turn programmer, you should watch this video.… Continue reading »

Mar
14

TopSolid 2011 – Continued Look at Cad Improvements

TopSolid 2011 is nearly here! As part of a continued segment, I will be talking about some of the key Cad or design improvements made to TopSolid 2011.  If you missed my last post regarding TopSolid’Design 2011, you can read it here. In this post, I will continue to talk about surfacing improvements to TopSolid… Continue reading »

Mar
14

TopSolid 2011 – First look at Cad improvements

TopSolid 2011 is nearly here! As part of a continued segment, I will be talking about some of the key Cad or design improvements made to TopSolid 2011.  If you missed my last post regarding TopSolid’Cam 2011, you can read it here. In this post, I will be talking about everyone’s favorite subject…surfacing!  What? It’s… Continue reading »

Mar
11

TopSolid 2011 – First look at Cam Improvements

TopSolid 2011 is getting ready to launch!  Over the next few weeks, I will try to introduce you to some of the new key features within TopSolid 2011. In this first post, I am going to start with a new 3D machining algorithm called “Morphing”. 3D Morphing does just what it sounds like it would… Continue reading »