by Bill Genc | Mar 14, 2018 | MillTurn U3000 Programming
Within the nineteenth video of this 25-video series on programming a Multus U3000 with TopSolid, we will delve into 5-axis milling by programming a swarf milling. Very importantly for swarf milling, you will see how easily TopSolid calculates the geometries based on...
by Bill Genc | Mar 12, 2018 | MillTurn U3000 Programming
Within the eighteenth video of this 25-video series on programming a Multus U3000 with TopSolid, I demonstrate finish milling using polar coordinates. After selecting side milling, TopSolid again illustrates one of its wonderful time-saving characteristics. All the...
by Bill Genc | Mar 7, 2018 | MillTurn U3000 Programming
Within the seventeenth video of this 25-video series on programming a Multus U3000 with TopSolid, I will demonstrate programming additional ID milling using TopSolid’s polar coordinate milling capabilities. TopSolid makes this operation much easier by identifying...
by Bill Genc | Mar 5, 2018 | MillTurn U3000 Programming
Within the sixteenth video of this 25-video series on programming a Multus U3000 with TopSolid, I will demonstrate programming the finish turn of our ID. You are reminded, once again, just how easy it is to copy feeds and speeds using TopSolid’s drag and drop...
by Bill Genc | Feb 28, 2018 | MillTurn U3000 Programming
Within the fifteenth video of this 25-video series on programming a Multus U3000 with TopSolid, I demonstrate programming the rough turn ID of our part. In the video, you will notice our turning view makes it a lot easier to see what’s going on. In this case,...
by Bill Genc | Feb 26, 2018 | MillTurn U3000 Programming
Within the fourteenth video of this 25-video series on programming a Multus U3000 with TopSolid, I will demonstrate how to copy a tool from another CAM file. I need to create a ID turning tool that can drill down the length of my part. I remember, however, that I...